Archives

PoldDeck is a roof sandwich panel with a core of rigid PU foam, the inner lining of laminate, fixed to the supporting structure by a fastener through the entire thickness of the panel.

External cladding is metal, as in the standard TD roof panels. PolDeck MD is a panel to be used mainly in livestock buildings, where there is great concentration of ammonia or the need for warming the existing roof covering.

PolDeck MD panel is suitable for use in horticulture, storage rooms, warehouses, barns, poultry houses, in buildings with pitched roof, at least 4 ° (7%) for continuous panels and 6 ° (10%) for panels joined alongside, with skylights, etc. Laminate / jut cladding can be cleaned with Karcher.

Advantages of roof sandwich panels PolDeck MD:

• Low water absorption – less than 1%
• Resistant to chemicals and biological agents:
  • Acids / very good
  • Alcohol / very good
  • Base / good
  • Solvents / good
  • Ammonia / very good
  • Molds / very good
• The surface of the laminate can be cleaned with water high pressure cleaners
• Operating temperature -40°C do 110°C
• Fire resistance: no dripping M class / French

PolDeck TD Europanels is a Trapezoidal roof panel with polyurethane foam. Fastening method it throughout to supporting beams by a self-drilling screw. PolDeck TD (Trapezoidal Deck) is an example of universal roof panel being a good choice for variety of buildings. Required slope is at least 4°(7%) for single panels and 6° (10%) for panels with skylights, overlapped etc.

Europanels offers sandwich panels with pre-cut of the internal facing – overlapping L and R for a gutter (Z) joining on length etc. 50-300mm

Sandwich panels are ready to use composites. It is extremely important to make a proper measurement of the length of panels to be installed, to avoid ordering too long (unnecessary waste) or too short ones (which sometimes makes it impossible to assemble at all). Length of the plate should be specified in the building design. Panels shall also be measured on the basis of the finished supporting structure as this could differ from plan. Customer / buyer are responsible for correctness of the lengths specification (professionally called “cutting list”).

Roof supporting structure, designed for mounting panels can be made out of steel, wood or reinforced concrete. For each of these types of structures there are different, specialized fastening solutions in EuroPanels offer.
Be sure to maintain proper spacing of the purlins and check their parameters: profile type, length and width etc. according to the construction project. The supporting structure is the load bearing for the panels, which provide loads (snow, wind and rain).

Due to the side effects of strong sunlight, UV and extreme temperatures which heat up the surface of the roof, we recommend that roof panels shall be made in the white (for example RAL 9010). Also important is to use the expansion joints and joining panels of length with overlapping in order to “shorten” total length of a single panel. Thus allows a proper “work” on the panels’ structure and compensation of changes in the skins length affected by extensive heat.